Unfortunately I haven’t had as much time as I would like to devote to the blog recently, but I hope to be able to post more in the near future as I get a little more free time in my schedule. While answering emails today I realized that it might be time  for another installment of Reader Mailbag:

Hi again Jon.

I received a full cap based on my new mold design a couple of weeks ago, and I have been experimenting with it since then. While I don’t think it’s 100% perfect, I feel it’s going the right way. There are some things I would like to ask you about again;
1. The system is quite “fluffy” when it arrives (I was aware of this from before). It seems very thick, and when wetting it things look a lot better. Over time (while wearing), does this change? I got the feeling that I’d have to apply styling products it to make it look good all the time. What about you? Do you depend on using styling products to make it look realistic? Is your system as “fluffy” as it was when you got it from the factory?

There is a difference between “fluffy” and “extremely thick”. If the density is ok it will settle down after a few washings.  If it is simply way too thick, it might be hard to get a realistic look. Depending upon how thick it is, hair products can be used to make it appear thinner.

2. The ventilation was not OK this time either (better than the first time though), so I bought a lancet and startet cutting on my own to get rid of the misplaced hairs in the temple hairline (a few of them are pointing straight forward, when they should just lay down). It seems that drawing arrows on the mold wasn’t enough. What do you think? Should I try to tell them one more time, or should I just add 0.1-0.3cm or something to the temple hairline and just customize it myself when I receive it?  Since I had to cut past my measured hairline, it didn’t look natural (to much recession), but the appearance of the hairs was great, and it did look like they grew out of my head. I think this is definitely the most tricky part in making this work. I think it is an advantage to be able to customize on your self, since you actually can’t guarantee that the system you get will be perfectly ventilated (at least it doesn’t seems that way).
Looking forward to hear from you!
Y

Drawing arrows is always a good idea but it’s no guarantee that it will be made perfectly. It’s always better to have a finely crafter hairline that was tied by the ventilators, but as you know this is a hit and miss thing. I do lots of modifications to my units, even at the hairline if needed, BUT….the results you get will depend upon how the unit was made at the factory. In other words, if they tied small knots and bleached them well extending 3/4″ of an inch back from the hairline, you can get away with a lot of cutting and still maintain realism. On the other hand, if the ventilator only ties the first 1/4″ really well, you are going to have to be careful that you don’t cut all the way back into bigger, (possibly unbleached) knots or risk losing realism. Of course this is less of an issue if you aren’t exposing hairline…

Bottom line- don’t be afraid to get in and cut the lace and pluck some hairs (this can be done easily with eyebrow tweezers after soaking the area with leave-in conditioner) to achieve the look you want. Just make sure you inspect the unit first to make sure that you aren’t going to be losing realism in critical areas.

Good luck, and send pictures when you get things ironed out!